Systematic convergence of nonlinear stochastic estimators on the Special Orthogonal Group SO(3)

This paper introduces two novel nonlinear stochastic attitude estimators developed on the Special Orthogonal Group with the tracking error of the normalized Euclidean distance meeting predefined transient and steady‐state characteristics. The tracking error is confined to initially start within a predetermined large set such that the transient performance is guaranteed to obey dynamically reducing boundaries and decrease smoothly and asymptotically to the origin in probability from almost any initial condition. The proposed estimators produce accurate attitude estimates with remarkable convergence properties using measurements obtained from low‐cost inertial measurement units. The estimators proposed in continuous form are complemented by their discrete versions for the implementation purposes. The simulation results illustrate the effectiveness and robustness of the proposed estimators against uncertain measurements and large initialization error, whether in continuous or discrete form.     

Computer‐aided design methodology for linearity enhancement of multiwatt GaN HEMT amplifiers using multiple parallel devices

This article presents a design methodology for linearizing GaN HEMT amplifiers based on splitting a large FET into multiple parallel FETs with same total gate periphery and by biasing them individually. By varying the biases, the magnitude and the phase of the IMD3 components at the output of FET changes. A detailed simulation methodology using commercial microwave CAD software is presented. Simulation results show that by biasing one device in Class AB and other(s) in deep Class AB mode, IMD3 components of parallel FETs can be made out of phase to each other leading to cancellation and improvement in linearity. Three prototype circuits were simulated using (a) a single 5 mm FET (1 × 5 mm), (b) two parallel 2.5 mm FETs (2 × 2.5 mm), and (c) four parallel 1.25 mm FETs (4 × 1.25 mm), for a total gate periphery of 5 mm, over the frequency range of 0.8 to 1.0 GHz. IMD3 improvement up to 20 dBc was achieved with the 4 × 1.25 mm circuit when the FET biases were optimized. Measurement results show improvement in linearity up to 20 dBc for 4 × 1.25 mm circuit. The proposed method improves linearity without a substantial penalty on the power consumption and is straightforward to implement.     

Zone model predictive control for pressure management of water distribution network

In the water distribution network (WDN), although the water demand of the node is changing constantly, the water quantity and water pressure of the node need to be met at each moment. To realize energy saving and consumption reduction, it is proposed to control the nodal water head of WDN in an appropriate narrow range. The frequent large fluctuation of the water demand, which may lead the water pressure exceed the expected range, increases the difficulty of the zone control. To realize optimized WND control, a novel zone predictive control is proposed, where two switching cases are considered. The switching condition is whether there are feasible solutions to keep the pressure within the expected region over the prediction horizon. When the condition is satisfied, the controller minimizes the variation of inputs with constraints of pressure range for ensuring the tank level staying within the expected zone and obtaining optimal economic cost. When the current pressure is out of the expected region or the condition is not satisfied due to the large variation of water demand, a reference trajectory of outputs is introduced, which is combined with the inputs as an optimization variable, and the constraints of expected zone are moved from the output to the introduced reference trajectory. Through minimizing the distance between reference trajectory and output, the controller will keep the tank level from deviating too far from the expected zone and will drive the tank level rapidly into the expected zone once the tank level exceeds the expected range. An application of the proposed zone MPC to WDN in Shinan District of Shanghai is given to illustrate its effectiveness.     

2种灰色模型在矿区地表沉陷预计中的适用性

目前矿区地表单点沉陷动态预计方法主要基于传统的水准测量数据,监测方法单一,成本高,观测点易破坏,不能保证地表形变信息的实时性,且采用灰色模型进行地表沉陷预计时只针对单一模型的应用,没有结合模型自身特点分析其适用性。以袁店二矿7221工作面为试验区域,采用合成孔径雷达差分干涉测量技术监测矿区地表沉陷量,分别建立了描述沉陷量与时间关系的GM(1,1)与灰色Verhulst模型进行地表沉陷量预计,实现了矿区地表沉陷监测与动态预计一体化。通过比较、分析GM(1,1)与灰色Verhulst模型对地表沉陷量的拟合及预计结果,得出了2种灰色模型在矿区地表沉陷预计中的适用性:在矿区开采沉陷开始至活跃前期,若地表单点沉陷量曲线呈近似单峰型,则宜采用GM(1,1)进行短期预计;当矿区地表沉陷进入衰退阶段,单点沉陷量曲线呈平底饱和状态,则宜采用灰色Verhulst模型进行中长期预计。     

海上稠油油田蒸汽吞吐产量确定新方法

针对目前蒸汽吞吐产量预测模型假设条件简单、普适性差等问题,一般采用测试法和类比法综合确定海上稠油油田蒸汽吞吐初期产量。由于目前海上油田通常只开展常规测试,无法直接获得热采开发初期产量。笔者提出海上稠油油田蒸汽吞吐初期产量确定新方法,建立蒸汽吞吐相对于常规开发的初期产量倍数预测模型,通过蒸汽吞吐产量倍数,将常规测试确定的产量转化为蒸汽吞吐产量。研究表明,蒸汽吞吐初期产量倍数主要受储集层渗透率、原油黏度、注入强度、蒸汽干度等因素影响,利用正交试验设计和多元回归等方法,建立海上稠油油田蒸汽吞吐初期产量倍数与油藏地质参数及注入参数之间的非线性预测模型,该模型经实际生产数据验证,预测误差小于5%,可靠性高,能够为海上稠油油田蒸汽吞吐初期产量的确定提供依据。     

Multi-objective optimal allocation strategy for the energy internet in Huangpu District,Guangzhou, China

To improve the overall efficiency of the energy system, the basic structure for the energy internet of coordination and optimization of “generation-grid-load-storage” of Huangpu District, Guangzhou, China is designed, while the arrangement for the output of centralized and distributed energy module and energy storage are proposed. Taking economic benefit maximization, environmental benefit maximization and energy efficiency maximization as sub-objectives, the mathematical model of multi-objective optimal allocation and operation strategy of the energy internet is established considering supply-demand balance constraints, equipment characteristic constraints, operation mode constraints, and energy conditions constraints. The calculation results show that without considering the outsourced electricity, the balanced strategy, the economic development strategy, the environmental protection strategy, and the energy efficiency strategy are obtained by calculation, which are all superior to the traditional energy supply strategy. Moreover, considering the outsourced electricity, the proportion of outsourced electricity to total electricity is 19.8%, which is the system optimization of the energy internet under certain power demand. Compared with other strategies without outsourced electricity, the outsourced electricity strategy can have a certain emission reduction effect, but at the same time reduce the economic benefit. Furthermore, the huge difference in demand for thermal and cooling load between industrial and commercial areas results in the installed capacity of gas distributed energy stations in industrial areas being nearly twice as large as that in commercial areas. The distributed photovoltaic power generation is allocated according to the proportion of the installed roof areas of photovoltaic power generation system in residential, industrial, and commercial areas.     

Performance-based modelling of long-term deterioration to support rehabilitation and investment decisions in drinking water distribution systems

Managing the urban drinking water system in the long term in order to maintain system performance can be challenging due to the difficulty of modelling future deterioration of the networks. This paper establishes a methodology for cohort survival models where historical (empirical) data on decommissioning ages of pipes are used to calibrate survival functions of pipe cohorts according to service level targets. The benefit of the approach is that remaining useful life of pipes, future renewal rates and investment needs can be governed by a required level of service in the network. A case study shows how the methodology can be applied to a cohort of drinking water pipes to create a ‘calibration curve’, which is a survival function calibrated with empirical data.     

Relevance- and interface-driven clustering for visual information retrieval

Search results of spatio-temporal data are often displayed on a map, but when the number of matching search results is large, it can be time-consuming to individually examine all results, even when using methods such as filtered search to narrow the content focus. This suggests the need to aggregate results via a clustering method. However, standard unsupervised clustering algorithms like $K$-means (i) ignore relevance scores that can help with the extraction of highly relevant clusters, and (ii) do not necessarily optimize search results for purposes of visual presentation. In this article, we address both deficiencies by framing the clustering problem for search-driven user interfaces in a novel optimization framework that (i) aims to maximize the relevance of aggregated content according to cluster-based extensions of standard information retrieval metrics and (ii) defines clusters via constraints that naturally reflect interface-driven desiderata of spatial, temporal, and keyword coherence that do not require complex ad-hoc distance metric specifications as in $K$-means. After comparatively benchmarking algorithmic variants of our proposed approach – RadiCAL – in offline experiments, we undertake a user study with 24 subjects to evaluate whether RadiCAL improves human performance on visual search tasks in comparison to $K$-means clustering and a filtered search baseline. Our results show that (a) our binary partitioning search (BPS) variant of RadiCAL is fast, near-optimal, and extracts higher-relevance clusters than $K$-means, and (b) clusters optimized via RadiCAL result in faster search task completion with higher accuracy while requiring a minimum workload leading to high effectiveness, efficiency, and user satisfaction among alternatives.     

A comparative study for consistency-based decision making with interval multiplicative preference relations

ABSTRACT

To ensure the reasonable application and perfect the theory of decision making with interval multiplicative preference relations (IMPRs), this paper continues to discuss decision making with IMPRs. After reviewing previous consistency concepts for IMPRs, we find that Krej?í’s consistency concept is more flexible and natural than others. However, it is insufficient to address IMPRs only using this concept. Considering this fact, this paper researches inconsistent and incomplete IMPRs that are usually encountered. First, programming models for addressing inconsistent and incomplete IMPRs are constructed. Then, this paper studies the consensus of individual IMPRs and defines a consensus index using the defined correlation coefficient. When the consensus requirement does not satisfy requirement, a programming model for improving consensus level is built, which can ensure the consistency. Subsequently, a procedure for group decision making with IMPRs is offered, and associated examples are provided to specifically show the application of main theoretical results.